@

max

Wednesday

How to operate Remote starter on 2011 Mitsubishi Endeavor SE

Its not very hard to use remote starter on your vehicle.
The procedure is as follows :----
To use the remote starter, you need to use only the remote starter fob (not the ignition key) buttons. All doors must be shut and the hood must be shut. The shifter must be in Park.
To start the vehicle, do the following:
Push the REQ button (bottom most button)
Light on fob will flash for two seconds
While light is flashing, push the Start button (the top most button, with a " * " on it.
After about two seconds the Hazard lights will flash and the engine will start.
To turn the engine off, do the following:
Push the REQ button
Light on fob will flash for two seconds
While light is flashing, push the Stop button (middle button, with a " --- " on it.
After about two seconds the engine will turn off.

The above mentioned procedure will help you.
----------
For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


No comments:

Post a Comment

@