Thursday

How to Run Self Diagnostic test on 2008 Honda Odyssey?

The Test of Honda AC

Air Conditioning System Diagnosis


The A/C control panel has a self-diagnostic function for heating, ventilation, and air conditioning system. To run the self-diagnostic function, do the following:

The details are as follows :----
  1. Turn the ignition switch to LOCK (0).
  2. Set the fan control dial OFF, the temperature control dial on Max Cool, the mode control dial to select Vent, and the rear fan control dial OFF.
  3. Turn the ignition switch to ON (II).
  4. Press and hold the recirculation control button. While holding the button, press the rear window defogger button five times within 10 seconds. The recirculation indicator blinks two times, then the self-diagnostic begins.
  5. If there is any problem in the system after self-diagnostic is finished, the recirculation indicator will blink Diagnostic Trouble Code (DTC) 1 through 15. If there are any problems in the evaporator temperature sensor circuit, the A/C indicator will blink DTC 7 or 8.
  6. If no DTC's are found, the indicator will not blink.
  7. Turn the ignition switch to LOCK (0) to cancel the self-diagnostic function. After completing repair work, run the self-diagnostic function again to make sure that there are no other malfunctions.
The number of times the recirculation indicator blinks and the associated detected item:


1: An open in the front air mix control motor circuit
2: A short in the front air mix control motor circuit
3: A problem in the front air mix control linkage, door, or motor
4: An open or short in the front mode control motor circuit
5: A problem in the front mode control linkage, doors, or motor
6: A problem in the front blower motor circuit
9: An open in the rear air mix control motor circuit
10: A short in the rear air mix control motor circuit
11: A problem in the rear air mix control linkage, door, or motor
12: An open in the rear mode control motor circuit
12: An open in the rear mode control motor circuit
13: A short in the rear mode control motor circuit
14: A problem in the rear mode control linkage, doors, or motor
15: A problem in the rear blower motor circuit

The number of times the A/C indicator blinks and the associated detected item:


7: An open in the evaporator temperature sensor circuit
8: A short in the evaporator temperature sensor circuit


----------------
This details will help you.
----------
If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.

For more Ac related help solutions.see the list below:-----


For car AC related and Heater related solutions. You can refer the options mentioned below:---

Car AC Blows Warm Air ?


How to test AUTO AC pressure?


AUTO Air Conditioning Troubleshooting?



AUTO A/C COOLING PROBLEM?


Fixing refrigerant leak?


How to locate Car AC Refrigerant leak?


CAR AC INTERMITTENT COOLING?


What causes INTERMITTENT COOLING on Car AC system?


Car AC making Noise?


BAD ODOR ON CAR AIR CONDITIONER?



How to Recharge Car's Air Conditioner

http://repairhelpcenter.blogspot.com/2011/10/how-to-recharge-cars-air-conditioner.html



No comments:

Post a Comment