@

max

Thursday

Honda Odyssey Control panel removal?

Its all fitted by connectors.The control panel removal procedure is as follows.See the diagram:----

Control Panel

Removal & Installation



  1. Remove the rear control panel from the roof.
  2. Disconnect the connector from the rear control panel.

    Click image to see an enlarged view
    Fig. Disconnect the connector (B) from the rear control panel (A) to remove
To install:
  1. Install the rear control panel in the reverse order of removal. After installation, operate the various functions to see whether works properly.




NOTE
This procedure requires the use of KTC trim tool set SOJATP2014, or equivalent trim tool set.

  1. Disconnect the negative battery cable.
  2. Remove the center panel, as follows:
    WARNING
    Be very careful not to scratch the dashboard and related parts. Use the appropriate tool from the KTC trim tool set to avoid damage when prying components. Be very careful not to bend the trim.

    1. Open the upper glove box.
    2. Gently pry up on the dashboard center panel to release the clips.

      Click image to see an enlarged view
      Fig. Gently pry up on the dashboard center panel (A) to release the clips
    3. Pry up on the outside edge of the dashboard center panel very carefully to detach the clips, then remove the panel.
    4. Disconnect the hazard warning switch/passenger's airbag off indicator connector (D), climate control unit connector (E), and interior lights switch connector (F).

      Click image to see an enlarged view
      Fig. Pry up on the outside edge of the dashboard center panel (A) very carefully to detach the clips (B, C), then remove the panel. Disconnect the hazard warning switch/passenger's airbag off indicator connector (D), climate control unit connector (E), and interior lights switch connector (F)
    5. If necessary, remove the screws securing the driver's center vent, then separate it from the dashboard center panel.
  3. Remove the self-tapping screws and the climate control panel.

    Click image to see an enlarged view
    Fig. Remove the screws and dials (A) to remove the control panel (B)
To install:
  1. Install the control panel in the reverse order of removal. After installation, operate the various functions to see whether works properly.
  2. Install the center panel in the reverse order of removal, and note these items:
    1. Make sure all connectors are plugged in properly.
    2. Replace any damaged clips.
    3. Push the clips and hooks into place securely.
  3. Connect the negative battery cable.



This details will help you.
----------
If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.

------------

For more related help solutions,see the list below:-----

Car instrument cluster has no power?


How to replace Instrument Cluster on Acura Car Models?


How odometer works in cars?


How to trouble shoot speedometer?


Warning lights on and speedometer died?


ABS & Brake lights warning indicator steady on dash and speedometer not working for Dodge Ram?

Vehicles Cluster panel Not reading Miles?

http://schematicsdiagram.blogspot.com/2011/12/vehicles-cluster-panel-not-reading.html




No comments:

Post a Comment

@