How to Remove Driver side Blend Door Actuator on 2008 Honda Odyssey?

The procedure is as follows :-----

Blend Door Actuator FOR DRIVERS SIDE.


Driver-s Side

Specific to:
Honda Odyssey 2007-2008
  1. Remove the driver's dashboard lower cover.
  2. Remove the self-tapping screws and the duct.
  3. Disconnect the wiring harness from the front air mix control motor. Remove the self-tapping screws and the front air mix control motor from the heater unit.

    Click image to see an enlarged view
    Fig. Disconnect the wiring harness (A) and screws to remove the driver-s side air mix motor
To install:
  1. Install the motor in the reverse order of removal. Make sure the pin on the motor is properly engaged with the linkage. After installation, make sure the motor runs smoothly.

This details will help you.
If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.


How to Replace Blower Motor on 2008 Honda Odyssey?

How to Remove Blend Door Actuator on 2008 Honda Odyssey?

For Instructions regarding All types of car heater problem repairs.

All types of Car heater Problem troubleshooting?

Blower only blows warm air ?

AC cool air enters only the passenger compartment even with the heat control turn all the way?

Saturn Car Blower motor Only works on High?

No hot air from defrost vents?

Radiator replaced but still Car is over heating?

Ford ranger heater blows cold air?

Audi A4 blower motor blows Warm Air?

Heater stuck on defrost?

Where is Blower motor resistor located on 2006 Ford F 250?

Dodge Caravan AC Heater Control only works on high mode?

Honda Civic Blower Motor Only works on high mode?

How to Test and Replace Blower motor on car?

How to Replace Blower Motor Wheel?

No comments:

Post a Comment