1986 to 1993 Acura Stabilizer removal procedure?

the details are for Acura integra,Vigor and Legend car models.

The instructions are as follows :----


1986-89 Integra

Raise and safely support the rear of the vehicle. Remove the rear wheels.
Remove both caliper brackets and the stabilizer control arm.
Remove the stabilizer assembly mounting bolts and the right side beam cap.
Insert a wooden rod and tap the stabilizer out of the axle beam.

To install:
Install the stabilizer into the axle beam and tighten the self locking bolts last. Torque to 54 ft. lbs. (75 Nm). Tighten all the bushings and parts with rubber mounts with the weight of the vehicle on the wheels.
Install the beam cap and caliper brackets.

See Figures 1 and 2

Click image to see an enlarged view
Fig. Fig. 1: Removing the rear stabilizer-1986-89 Integra

Click image to see an enlarged view
Fig. Fig. 2: Tighten the self-locking bolts last after assembling the stabilizer in the axle beam-1986-89 Integra

This will help.

No comments:

Post a Comment