How to Replace Fuel Pump on Ford Windstar?

The details to replace Fuel pump on Ford Windstar vehicle is as follows: -----

Fuel Pump
REMOVAL & INSTALLATION Instructions are as follows:----

NOTE

To gain access to the fuel pump, it is necessary to remove the fuel tank.

1. Depressurize the fuel system and remove the fuel tank from the vehicle.
2. Remove any dirt that has accumulated around the fuel pump module attaching flange to prevent it from entering the tank during service. 
   
   
   
   Fig. In-tank electric fuel pump and related components
3. Turn the fuel pump module locking ring counterclockwise using a locking ring removal tool or a brass drift, and remove the locking ring.
4. Remove the fuel pump module.
5. Remove the seal gasket and discard it.

To install:

1. Put a light coating of grease on a new seal ring to hold it in place during assembly. Install it in the fuel tank ring groove.
2. Insert the fuel pump module into the fuel tank, then secure it in place with the locking ring. Tighten the ring until secure.
3. Install the tank in the vehicle.
4. Install a minimum of 10 gallons (38L) of fuel and check for leaks.
5. Install a pressure gauge on the throttle body valve and turn the ignition ONfor 3 seconds. Turn the key OFF , then repeat the key cycle 5 to 10 times until the pressure gauge shows at least 30 psi. (207 kPa).
6. Check for fuel leaks at the fittings.
7. Remove the pressure gauge.
8. Start the engine and check for fuel leaks.

This details will help.

Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html