Ford Taurus 2008 and 2009
Crankshaft Damper (Balancer)
REMOVAL & INSTALLATION procedure details are as follows :---
Car repair guide?
http://technoanswers.blogspot.in/2012/03/car-repair-guide.html
Crankshaft Damper (Balancer)
REMOVAL & INSTALLATION procedure details are as follows :---
- With the vehicle in NEUTRAL, position it on a hoist.
- Remove the accessory drive belt and power steering belt.
- Use a strap wrench to hold the crankshaft pulley and remove the crankshaft pulley bolt.
- Using a 3-jaw puller, remove the crankshaft pulley.
To install:
- Lubricate the front cover and the crankshaft front seal inner lip with clean engine oil.
- Lubricate the outside diameter sealing surfaces with clean engine oil.
- Using Crankshaft Vibration Damper Installer #303-102, install the crankshaft pulley.
- Install the bolt and washer. Using damper installer and seal installer, tool to hold the crankshaft pulley and tighten the bolt in 4 stages:
Stage 1: Tighten to 89 ft. lbs. (120 Nm).
Stage 2: Loosen one full turn.
Stage 3: Tighten to 37 ft. lbs. (50 Nm).
Stage 4: Tighten an additional 90 degrees.
- Install the accessory drive belt and power steering belt.
This details will help.
Thanks.
FOR MORE HELP GO TO: ---
No comments:
Post a Comment