max

Tuesday

How to Replace Blower motor on Ford,mercury and Lincoln?


The procedure is similar for Ford Crown Victoria, Mercury Grand Marquis, Lincoln Town Car.  

Blower motor replacing details are as follows:----

  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Disconnect battery negative cable from battery and properly isolate to prevent accidental reconnection.
  3. Disengage the wire harness connectors from the retainer.
  4. Disconnect the blower motor electrical connector.
  5. Remove the motor cooling hose.
  6. Remove the screws and remove the blower motor.
    NOTE
    Prior to removing a wheel that is to be reused, clean any corrosion from the blower motor shaft to prevent damage to the wheel mounting shaft.
  7. Remove the wheel from the blower motor as follows:

    Remove the push clip.
    Remove the wheel from the blower motor.

    Click image to see an enlarged view
    Fig. Blower motor cooling hose


    Click image to see an enlarged view
    Fig. Blower motor mounting plate


    Click image to see an enlarged view
    Fig. Blower motor
To install:
  1. Install or connect the following:

    Wheel to the blower motor, if removed.
    Blower motor and securely tighten the screws.
    Motor cooling hose
    Blower motor electrical connector
    Wire harness retainers


This details will help.
Thanks.


FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html



No comments:

Post a Comment