max

Thursday

How to remove HVAC Assembly on Ford Taurus?

The details for 2008 and 2009 Ford Taurus.

Hvac Assembly Removal & Installation instructions are as follows:----


  1. Remove the instrument panel assembly. Refer to Instrument Panel.
  2. Position the instrument panel with the passenger side supported as shown. 

    image
    Fig. Instrument panel positioned for HVAC assembly removal
  3. Remove the 2 floor duct screws and remove the floor duct.
  4. Detach the in-vehicle temperature sensor aspirator from the heater core and evaporator core housing.
  5. Remove the 6 heater core and evaporator core housing bolts.
  6. Disconnect the 3 electrical connectors and detach the wire harness pin-type retainer.
  7. Detach the 3 wire harness pin-type retainers and disconnect the electrical connector.
  8. Disconnect the 3 electrical connectors, detach the wire harness pin-type retainer and detach the instrument panel wire harness from the heater core and evaporator core housing.
  9. Remove the heater core and evaporator core housing.
  10. To install, reverse the removal procedure.
  11. Tighten the 6 heater core and evaporator core housing bolts to 80 inch lbs. (9 Nm).


This will help.
Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?



No comments:

Post a Comment