How to replace Blower motor resistor on 2001 Mazda Protege?

The blower motor only runs on high mode,but not on any other mode.This indicates problem with blower motor resistor.In this case the blower motor resistor has to be replaced.

To replace blower motor resistor for Mazda protege,click the link below :----

If you concerns that the blower motor speed only works on the first position and stops blowing when switched to any other speed, I would start by replacing the blower motor resistor.

Here is the test procedure to check.
  1. Remove the glove compartment.

  1. Disconnect the resistor connector.

  1. Verify that the resistance between the terminals of the resistor is as indicated in the table.
    • If not as specified, replace the resistor.
  1. Disconnect the negative battery cable.
  2. Remove the glove compartment

  1. Remove in the order indicated below.
  1. Connector
  2. Resistor
  1. Install in the reverse order of removal.

This will help.
See below latest solved car problems :----

How to replace blower motor on Buick regal?

Heater/AC blower motor not working on 1995 Isuzu Trooper?

Replace blower motor?

How to replace blower motor fan assembly on 2000 GMC Yukon?

Audi A4 blower motor blows Warm Air?

Heater stuck on defrost?

Where is Blower motor resistor located on 2006 Ford F 250?

Dodge Caravan AC Heater Control only works on high mode?

Honda Civic Blower Motor Only works on high mode?

How to Test and Replace Blower motor on car?

How to Replace Blower Motor Wheel?

How to Replace Blower Motor on 2008 Honda Odyssey?

Where is blower motor relay located on 2005 Ford F-350?

No comments:

Post a Comment