PLEASE HELP.
I NEED TO REPLACE INKJET CARTRIDGE FROM MY HP PRINTER.
2) Then lift the cover on the right side of the printer to the top.
3) Now the cartridge carriage will automatically move from left to right for few seconds then the carriage will stop to the right corner where you lifted the cover.
4) Then to remove the cartridge out its a very very simple method.
While fitting the cartridge if you are getting it hard to fit then this points will help you.
1)Check on the cartridge there is brown dotted circuit.
2)In the printer also there is brown dotted circuit.
3)This both circuit should match each other while fitting.
4)So you get in what position to hold the cartridge.
5)The sticker on the cartridge should be on top position.
6) It hardly takes 2 second to remove and reinsert the cartridges ,once the cartridge carriage gets stopped in the position from where you can remove the cartridges.
7) Let the cartridge carriage get stopped in the right position then only remove the cartridge,other wise the cartridges will get blocked.
-----------
Thank you.
I NEED TO REPLACE INKJET CARTRIDGE FROM MY HP PRINTER.
THE PRINTER MODEL IS HP office-jet 4215.
I HAVE NEW CARTRIDGES WITH ME,BUT I DONT KNOW HOW TO REPLACE THE CARTRIDGE.
--------
OK.
Its not at all hard to replace the cartridge from printer.
1) Turn the printer ON.2) Then lift the cover on the right side of the printer to the top.
3) Now the cartridge carriage will automatically move from left to right for few seconds then the carriage will stop to the right corner where you lifted the cover.
4) Then to remove the cartridge out its a very very simple method.
- Place the thumb of your hand on the cartridge top and one finger on the base of the cartridge and slowly pull it towards down position.
- The cartridge will get unlocked as you push it bit lower side the down side.then once the cartridge is got down it will get loose so easily pull the cartridge towards yourself.
- It will come out.In the same way do it for other cartridge also.
While fitting the cartridge if you are getting it hard to fit then this points will help you.
1)Check on the cartridge there is brown dotted circuit.
2)In the printer also there is brown dotted circuit.
3)This both circuit should match each other while fitting.
4)So you get in what position to hold the cartridge.
5)The sticker on the cartridge should be on top position.
6) It hardly takes 2 second to remove and reinsert the cartridges ,once the cartridge carriage gets stopped in the position from where you can remove the cartridges.
7) Let the cartridge carriage get stopped in the right position then only remove the cartridge,other wise the cartridges will get blocked.
-----------
Thank you.
No comments:
Post a Comment